Hook Extender (pair)
The hooks on KVgear stands are designed to safely grip a wide range of gear while remaining unobtrusive. But there are a few situations where extra grip is needed.
If the bottom front face of gear is angled AND if it's on a steep tier of a stand, it's possible for the gear to slip. The following have angled bottom front faces: Roland RC-202, RC-505, TR-626, and early Roland Aira synths (TR-8, MX-1, TB-3, VT-3), microKorg. The following are considered steep tiers: angled support arms on Gear Rail and SubPiggy, upper tier of Adapt L2, either tier of Adapt L1 or L2 when set up in steep orientation, EDS-UX, Boo-2, Boo-3, Utility M3, Volc45.
NOTE: The TR-8S has a square front face and does NOT need Hook Extenders.
Those people living in earthquake-prone areas might want to consider adding Hook Extenders for all gear on all KVgear stands.
INSTALLATION: To install, simply pull off the rubber trim on a hook tab on your KVgear stand, then push a Hook Extender onto the bare hook tab. The Hook Extender will naturally be a little flexible. Although not required, you may use superglue (cyanoacrylate adhesive) to permanently affix the Hook Extenders to a stand.
Dimensions: 1" (25 mm) long each
Compatible stands include:
- Stiletto Angled
- Volc 45
- Gear Rail angled arms
- SubPiggy angled arms